Logo

U0835 Engine Trouble Code

Meaning of U0835 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U0835 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for U0835 code is occuring now you should check U0835 repair processes.
Now don't ask yourself; What should you do with U0835 code ?
The solution is here :

U0835 Possible Solution:

U0835 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

U0835 Code Meaning :

U 0 8 3 5
OBD-II Diagnostic Network (U) Trouble Code For Engine Intake Valve Control Solenoid Circuit Low Engine Oil Temperature Sensor Malfunction Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector) Crankshaft Position Sensor B Circuit Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U0835 OBD-II Diagnostic Network (U) Trouble Code Description

U0835 engine trouble code is about Crankshaft Position Sensor B Circuit Malfunction.

Main reason For U0835 Code

The reason of U0835 OBD-II Engine Trouble Code is Engine Oil Temperature Sensor Malfunction.

U0835 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.